Remote Management; Remote Management Limitations; Figure 229 Menu 24.11 - Remote Management Control; Table 142 Menu 24.11 - Remote Management Control - ZyXEL Communications P-793H User Manual

36.4 Remote Management

To disable remote management of a service, select Disable in the corresponding
Server Access field. Enter 11 from menu 24 to bring up Menu 24.11 - Remote
Management Control.
Figure 229 Menu 24.11 – Remote Management Control
TELNET Server:
Server Port = 23
Secured Client IP = 0.0.0.0
FTP Server:
Server Port = 21
Secured Client IP = 0.0.0.0
HTTP Server:
Server Port = 80
Secured Client IP = 0.0.0.0
The following table describes the fields in this screen.
Table 142 Menu 24.11 – Remote Management Control
FIELD
TELNET Server
FTP Server
HTTP Server
Server Port
Server Access
Secured Client
IP
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm
or ESC to Cancel" to save your configuration, or press [ESC] to cancel.

36.4.1 Remote Management Limitations

Remote management over LAN or WAN will not work when:
A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP
1
or Web service.
P-793H v2 User's Guide
Menu 24.11 - Remote Management Control
DESCRIPTION
Each of these read-only labels denotes a service that you may use to
remotely manage the P-793H v2.
This field shows the port number for the service or protocol. You may
change the port number if needed, but you must use the same port
number to access the P-793H v2.
Select the access interface (if any) by pressing [SPACE BAR], then
[ENTER] to choose from: LAN only, WAN only, ALL or Disable.
The default 0.0.0.0 allows any client to use this service to remotely
manage the P-793H v2. Enter an IP address to restrict access to a client
with a matching IP address.
Chapter 36 Menus 24.8 to 24.11
Server Access = ALL
Server Access = ALL
Server Access = ALL
409