Figure 196 Menu 24.1: System Maintenance - Status; Table 133 Menu 24.1: System Maintenance - Status - ZyXEL Communications P-793H User Manual

Chapter 34 System Information & Diagnosis
To get to the System Status:
Enter number 24 to go to Menu 24 - System Maintenance.
1
In this menu, enter 1 to open System Maintenance - Status.
2
There are three commands in Menu 24.1 - System Maintenance - Status.
3
Entering 1 drops the WAN connection, 9 resets the counters and [ESC] takes you
back to the previous screen.

Figure 196 Menu 24.1: System Maintenance - Status

Node-Lnk Status
1-ENET
2
3
4
5
6
7
8
My WAN IP (from ISP): 0.0.0.0
Ethernet:
Status: 100M/Full Duplex Tx Pkts: 4210
Collisions: 0
CPU Load =
The following table describes the fields present in Menu 24.1 - System
Maintenance - Status. These fields are read-only and meant for diagnostic
purposes. The upper right corner of the screen shows the time and date.

Table 133 Menu 24.1: System Maintenance - Status

FIELD
Node-Lnk
Status
TxPkts
RxPkts
376
Menu 24.1 - System Maintenance - Status
TxPkts
N/A 0
N/A 0
N/A 0
N/A 0
N/A 0
N/A 0
N/A 0
N/A 0
1.27%
COMMANDS: 1-Reset Counters
DESCRIPTION
This field is the remote node index number and link type
(encapsulation).
This field displays Down (line is down), Up (line is up or connected) if
you're using Ethernet encapsulation and Down (line is down), Up (line
is up or connected), Idle (line (ppp) idle), Dial (starting to trigger a
call) and Drop (dropping a call) if you're using PPPoE encapsulation. It
displays N/A if the port is not connected.
This is the number of packets transmitted from the P-793H v2 to the
remote node.
This is the number of packets received by the P-793H v2 from the
remote node.
RxPkts Errors Tx B/s
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
WAN:
Rx Pkts: 4466 Transfer Rate:
Press Command:
ESC-Exit
06:28:45
Sat. Jan. 01, 2000
Rx B/s Up Time
0 0 0:00:00
0 0 0:00:00
0 0 0:00:00
0 0 0:00:00
0 0 0:00:00
0 0 0:00:00
0 0 0:00:00
0 0 0:00:00
Line Status: Down
0 kbps
P-793H v2 User's Guide