Configuring Dynamic Dns - ZyXEL Communications P-793H User Manual

Chapter 24 General Setup
Table 109 Menu 1: General Setup (continued)
FIELD
Contact
Person's Name
Domain Name
Edit Dynamic
DNS
Route IP
Bridge345
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to
Confirm..." to save your configuration, or press [ESC] at any time to cancel.

24.1.1 Configuring Dynamic DNS

To configure Dynamic DNS, set the P-793H v2 to router mode in menu 1 or in the
MAINTENANCE Device Mode screen and go to Menu 1 - General Setup and
308
DESCRIPTION
Enter the name of the person to contact for questions about the P-793H
v2. You can enter up to 30 characters, or you can leave this field blank.
Enter the domain name (if you know it) here. If you leave this field
blank, the ISP may assign a domain name via DHCP. You can go to menu
24.8 and type "sys domain name" to see the current domain name used
by your router.
The domain name entered by you is given priority over the ISP assigned
domain name. If you want to clear this field just press [SPACE BAR] and
then [ENTER].
Press [SPACE BAR] and then [ENTER] to select Yes or No (default).
Select Yes to configure Menu 1.1: Configure Dynamic DNS discussed
next.
Select Yes to enable IP-based routing in the P-793H v2. This is not
effective for a specific remote node unless you enable IP-based routing in
the remote node too. See
in Section 28.3 on page
You should enable Route IP, Bridge, or both in this screen. If you
disable Route IP and Bridge, the device does not send traffic between
the LAN ports and remote node.
If Route IP is Yes, select Yes in this field to enable bridging in the P-
793H v2 for protocols that are not supported by IP-based routing (for
example, SNA).
If Route IP is No, select Yes in this field to enable bridging in the P-
793H v2 for all protocols.
In either case, this setting is not effective for a specific remote node
unless you enable bridging in the remote node too. See
Remote Node Profile (nodes 1-7)
You should enable Route IP, Bridge, or both in this screen. If you
disable Route IP and Bridge, the device does not send traffic between
the LAN ports and remote node.
Menu 11.1: Remote Node Profile (nodes 1-7)
326.
in Section 28.3 on page
Menu 11.1:
326.
P-793H v2 User's Guide