The Static Route Screen; Figure 91 Advanced > Static Route; Table 58 Advanced > Static Route - ZyXEL Communications P-793H User Manual

Chapter 13 Static Route

13.2 The Static Route Screen

Use this screen to view the static route rules. Click Advanced > Static Route to
open the Static Route screen.
Figure 91 Advanced > Static Route
The following table describes the labels in this screen.
Table 58 Advanced > Static Route
LABEL
#
Active
Name
Destination
Gateway
Subnet Mask
Modify
Apply
Cancel
204
DESCRIPTION
This is the number of an individual static route.
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
This parameter specifies the IP network subnet mask of the final
destination.
Click the Edit icon to go to the screen where you can set up a static route
on the P-793H v2.
Click the Remove icon to remove a static route from the P-793H v2. A
window displays asking you to confirm that you want to delete the route.
Click this to save your changes.
Click this to restore your previously saved settings.
P-793H v2 User's Guide