Enter "quit" to exit the ftp prompt. The P-793H v2 will automatically restart after a
8
successful restore process.
35.4.2 Restore Using FTP Session Example
Figure 211 Restore Using FTP Session Example
Refer to
Section 35.3.5 on page 390
TFTP and FTP over WAN.
35.4.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure
shown next. Procedures using other serial communications programs should be
similar.
Display menu 24.6 and enter "y" at the following screen.
1
Figure 212 System Maintenance: Restore Configuration
The following screen indicates that the Xmodem download has started.
2
Figure 213 System Maintenance: Starting Xmodem Download Screen
P-793H v2 User's Guide
Chapter 35 Firmware and Configuration File Maintenance
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...CCCCCCCCC
to read about configurations that disallow
395