Connect The P-793H V2S; Figure 25 Wan > Internet Connection > Service Type Of B; Figure 26 Wan > Internet Connection > Service Type Of C - ZyXEL Communications P-793H User Manual

Chapter 5 Tutorials
Select ATM as the Transfer Mode. Set the VPI, VCI, Multiplexing, and
3
Encapsulation to the same values you set in the server.
Scroll down to the Service Type section. In the Service Mode field, select 2
4
wire. In the Service Type field, select Client. The rest of the fields will be
negotiated with the server. Click Apply.
Figure 25 WAN > Internet Connection > Service Type of B
Repeat the above steps 1 to 4 for the second client P-793H v2 on C's side. The
5
Service Type should look like the following.
Figure 26 WAN > Internet Connection > Service Type of C

5.3.3 Connect the P-793H v2s

Connect the DSL ports on the P-793H v2s together, and wait while the P-793H v2s
automatically establish the connection. Make sure that the Y-cable is connected to
the proper DSL outlets. The Y-cable connector marked DSL1 must be connected
to the outgoing DSL 1 telephone jack and the Y-cable connector marked DSL2
must be connected to the outgoing DSL 2 telephone jack.
When the connection is established, the DSL1, DSL2, and INTERNET lights turn
on. It takes up to half a minute to establish the connection. If the P-793H v2s do
not establish the connection, verify that the settings are correct.
72
P-793H v2 User's Guide