System Information And Console Port Speed - ZyXEL Communications P-793H User Manual

Table 133 Menu 24.1: System Maintenance - Status (continued)
FIELD
Errors
Tx B/s
Rx B/s
Up Time
My WAN IP
(from ISP)
Ethernet:
Status
Collisions
TxPkts
RxPkts
WAN
Line Status
Transfer Rate
CPU Load
You may enter 1 to reset the counters or [ESC] to return to menu 24.
34.3 System Information and Console Port
Speed
This section describes your system and allows you to choose different console port
speeds. To get to the System Information and Console Port Speed:
Enter 24 to go to Menu 24 - System Maintenance.
1
Enter 2 to open Menu 24.2 - System Information and Console Port Speed.
2
P-793H v2 User's Guide
DESCRIPTION
This is the number of error packets on this connection.
This field shows the transmission rate in bytes per second on this port.
This field shows the reception rate in bytes per second on this port.
This is the total amount of time the this channel has been connected to
the remote node.
This is the IP address assigned by your ISP or the static IP address you
set up in menu 4.
This section displays information about the LAN ports.
This field displays the speed and duplex settings of the LAN ports.
This is the number of collisions on this port.
This is the number of transmitted packets on this port.
This is the number of received packets on this port.
This section displays information about the WAN port.
Note: In a point-to-2points connection this field only displays line 1
status.
This field displays the port speed and duplex setting if you're using
Ethernet encapsulation and Down (line is down or not connected), Idle
(line (ppp) idle), Dial (starting to trigger a call) or Drop (dropping a
call) if you're using PPPoE encapsulation.
This field shows the transmission speed in kilobits per second on this
port.
This field displays the percentage of CPU utilization.
Chapter 34 System Information & Diagnosis
377