The Static Route Screen; Static Route Add/Edit - ZyXEL Communications eircom D1000 User Manual

Chapter 7 Static Route

7.2 The Static Route Screen

Use this screen to view the static route rules. Click Network Setting > Static Route to open the
Static Route screen.
Figure 74 Network Setting > Static Route
The following table describes the labels in this screen.
Table 30 Network Setting > Static Route
LABEL
Add new static
route
#
Destination IP
Gateway
Subnet Mask
Metric
Modify

7.2.1 Static Route Add/Edit

Use this screen to add or edit a static route. Click Add new Static Route Entry in the Routing
screen or the Edit icon next to the static route you want to edit. The screen shown next appears.
Figure 75 Network Setting > Static Route Add/Edit
110
DESCRIPTION
Click this to configure a new static route.
This is the number of an individual static route.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
This parameter specifies the IP network subnet mask of the final destination.
This is the number of transmission hops between this Device and the destination.
Click the Edit icon to go to the screen where you can set up a static route on the Device.
Click the Delete icon to remove a static route from the Device. A window displays asking
you to confirm that you want to delete the route.
eircom D1000 modem User's Guide