7.3.1
This setting selects print mode.
B-EP Mode OFF:
TPCL
TPCL1
C Mode
ESC/POS
Z Mode
S Mode
B-EP Mode ON:
TPCL
TPCL1
LABEL
REPEIPT
REPEIPT1
ESC/POS
Default value: TPCL
*Support mode (o:valid、x:invalid)
TPCL, TPCL1,
LABEL
o
7.3.2
When a printing ratio per line is high, the value of this setting is changed to prevent print tone from becoming lighter.
AUTO1
AUTO
AUTO2
Default value: AUTO1 (none, 2 division)
<Commentary>
If it uses normal battery, available conditions of AUTO2 is:
- Ambient temperature is over 10 degree.
- Battery level is over 4.
- Label pitch is less than 63mm.
And the movement is: after every 10 continuous prints, it stops 3 sec.
*Support mode (o:valid、x:invalid)
TPCL, TPCL1,
LABEL
o
CMD Setting
C Mode
o
Head Division Setting (HEAD DIV)
Automatic selection from none, 2 division
Automatic selection from 2 division (Print quality oriented)
Automatic selection from none, 2 division (Print speed oriented)
C Mode
o
ESC/POS
Z Mode
RECEIPT,RECEIP
T1
o
o
ESC/POS
Z Mode
RECEIPT,RECEIP
T1
o
o
-58-
S Mode
o
S Mode
o