Remove The Ac Power Supply Module - Cisco 8011-2X2XP4L Hardware Installation Manual

Replace Power Supply
Figure 31: Install DC Power Supply Module
1 Power supply handle

Remove the AC Power Supply Module

Before you begin
This section describes how to remove and replace the AC power supply.
Warning
Warning
Perform the following steps to remove and replace the AC power supply:
Step 1 Disconnect the power cord from the power source. Do not touch any metal on the power cord when it is still connected
to the power supply.
Step 2 Loosen the tie and remove the power cord from the tie-and holder.
Statement 1046 Installing or Replacing the Unit
To reduce risk of electric shock, when installing or replacing the unit, the ground connection must always be
made first and disconnected last.
If your unit has modules, secure them with the provided screws.
Statement 1074 Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Hardware Installation Guide for Cisco 8011-2X2XP4L PLE Service Endpoint Router
Remove the AC Power Supply Module
2 Power supply lock
59