To Position The Time Reference (Left, Center, Right); To Navigate The Time Base - Agilent Technologies 7000B Series User Manual

3 Displaying Waveforms

To position the time reference (left, center, right)

Time reference is the reference point on the display for delay time
(horizontal position).
1 Press [Horiz].
2 In the Horizontal Menu, press Time Ref; then, select:

To navigate the time base

You can use the [Navigate] key and controls to navigate through captured
data, marks in the serial decode Lister, or segmented memory acquisitions.
To navigate time
When acquisitions are stopped, you can use the navigation controls to play
through the captured data.
1 Press [Navigate].
2 In the Navigate Menu, press Navigate; then, select Time.
74
Left — the time reference is set to one major division from the left
•
edge of the display.
Center — the time reference is set to the center of the display.
•
Right — the time reference is set to one major division from the right
•
edge of the display.
A small hollow triangle (
position of the time reference. When delay time is set to zero, the
trigger point indicator () overlays the time reference indicator.
The time reference position sets the initial position of the trigger event
within acquisition memory and on the display, with delay set to 0.
Turning the Horizontal scale (sweep speed) knob expands or contracts
the waveform about the time reference point (). See
horizontal (time/div) scale"
Turning the Horizontal position (
moves the trigger point indicator () to the left or right of the time
reference point (). See
page 63.

at the top of the display grid marks the
on page 63.
) knob in Normal mode (not Zoom)
"To adjust the horizontal delay (position)"
InfiniiVision 7000B Series Oscilloscopes User's Guide
"To adjust the
on