To Reposition A Digital Channel; To Display Digital Channels As A Bus - Agilent Technologies 7000B Series User Manual

To reposition a digital channel

Press the [Digital] key to turn on the digital channels (the [Digital] key will
illuminate).
To select a waveform, push the knob in the Digital controls until the Select
indicator is lit; then, turn the knob. The selected waveform is highlighted
in red. To position the selected waveform, push the knob until the Pos
indicator is lit; then, turn the knob.
If a trace is repositioned over an existing trace the indicator at the left
edge of the trace will change from D
two digit channel number from 0 to 15) to D * . The " * " indicates that two
channels are overlaid.

To display digital channels as a bus

Digital channels may be grouped and displayed as a bus, with each bus
value displayed at the bottom of the display in hex or binary. You can
create up to two buses. To configure and display each bus, press the
[Digital] key on the front panel. Then press the Bus softkey.
Next, select a bus. Rotate the Entry knob, then press the Entry knob or
the Bus1/Bus2 softkey to switch it on.
InfiniiVision 7000B Series Oscilloscopes User's Guide
designation (where nn is a one or
nn
Digital Channels 17
Bus softkey
369