Toshiba B-EX4 SERIES Maintenance Manual page 88

5. SYSTEM MODE
[Method 2] Adjust the cut position fine adjustment value.
Operation example
Issue count: 2, Cut interval = 1
Cut position
▼
A
A
A
A B
B
A
When this procedure is used, one or more printed labels are left between the head and
the cutter. Therefore, these labels should be removed by an issue or a label feed.
(a) Cut position fine adjustment value calculation
The cut position fine adjustment value can be calculated using the following method.
If a back feed to the proper home position cannot be performed using this value, the
cut position should be adjusted with any value.
Cut position fine
adjustment value
Ex) Label pitch: 30.0 mm
Cut position fine
Adjustment value
Head position
▼
A
A B
A
A B
B C
B
B C
C
C
(Number of labels left
=
between head and cutter)
32.8 mm
= × (Label pitch)
Label pitch
32.8 mm
=
30.0 mm
= 1 × 30.0 mm
= +30.0 mm
(1) Idling
A B
(2) Completes printing the first label (A).
B C
C
(3) Feeds the label to the cut position, then cuts
B C
(4) Back feeds to the home position.
C
(5) Completes printing the second label (B).
(6) Feeds the label to the cut position, then cuts
C
(7) Back feeds to the home position.
(8) To eject label (B), feeds the third label (C).
(9) Feeds the label to the cut position, then cuts
(10) Back feeds to the home position.
5-40
5.5 PRINTER PARAMETER FINE ADJUSTMENT
×
(Label pitch)
* Any decimal remainders are
dropped.
× (30.0 mm)
the gap at the front of label (A).
the gap at the front of label (B).
the gap at the front of label (C).
EO18-33027