Toshiba B-EX4 SERIES Maintenance Manual page 31

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
NOTES: 1. You should change the selection switch setting depending on the issue mode. Improper setting may
affect the print quality.
STANDARD/PEEL OFF (STRIP):
REWINDER:
For the cut mode, the selection switch can be set to
either position.
2. The backing paper can be wound directly onto the Take-
up Spool or a paper core. When using the Take-up
Spool, detach the holder stopper by removing the B-3x4
screw. Otherwise, it may be difficult to pull out the wound
backing paper roll. When using a paper core, put the core
on the Take-up Spool with the Holder Stopper on it, and
attach the top edge of the backing paper to the core with
adhesive tape. The Take-up clip is not necessary.
This winding method is applicable to the Built-in Rewinder
mode.
10) Turn the head lever counterclockwise to Free position.
11) Open the ribbon shaft holder plate.
Head Lever
Lock position (Tag)
12) Raise the print head block until it stops.
Lock position (Label)
Batch or strip mode
Built-in rewinder mode
Selection Switch
Holder Stopper
Take-up Spool
Ribbon Shaft Holder Plate
Print Head Block
4-16
4.3 PEEL OFF MODULE (B-EX904-H-QM-R)
B-3x4
Screw
Take-up Clip
EO18-33027