Test / Test - Toshiba B-EX4 SERIES Maintenance Manual

5. SYSTEM MODE

5.11.1 Test / TEST

The following item related test is displayed.
ID Read / ID READ
It changes to reading test mode and the printer read RFID tag. The printer perform reading test by
pressing [ENTER] key. The reading data is displayed on LCD once RFID tag is read.
The error message is displayed on LCD if tag is not read.
Error content
No module or not available for communication /
NO RFID MODULE
No country setting / RFID CONFIG ERR
Read tag is different from setting tag / RFID
READ ERROR
Not available / NOT AVAILABLE
No response / NO RESPONSE
Time out / TIME OUT
Other error / UNKNOWN ERROR
The only tag which is selected by RFID tag type setting can be read. If tag type is different from RFID tag
type setting, RDID tag reading error is detected. Therefore select RFID tag type before this reading test.
The display is 16 columns and 2 lines.
Display example
English
1st line data X/Y, X: Tag number for result, Y: Total tag number
Most of the case, only 1 tag is read.
If UHF module is used, "Performance/AGC" id displayed on the 2
5.11.1.1 ID Read / ID READ
English
MODULE TYPE ERROR
COUNTRY CONFIG ERROR
READ ERROR
Confirm Setting or
set other Tag.
NOT AVAILABLE
NO REPONSE
READ TIMEOUT
set a RF-Tag on Ant.
UNKNOWN ERROR
nd
5-74
5.11 RFID Module Setting
line by decimal.
EO18-33027