Parameter Settings - Toshiba B-EX4 SERIES Maintenance Manual

5. SYSTEM MODE
<< PARAMETER SETTINGS >>
Item
MEDIA LOAD
FORWARD WAIT
FW/BK ACT.
HU CUT/RWD.
RBN SAVE
AUTO CALIB
Content
Media loading
Forward feed standby after
an issue
Forward feed standby action
Head-up operation in cut
issue mode, or use of the
rewinder
Ribbon saving system
setting
Pre-peel-off process setting
Back feed speed setting
Auto calibration setting
5-8
Print value
OFF Disable
STD Feed detected gap/mark
to stop position.
ECO Feed gap/mark between
head and sensor to stop
position.
ECO+BFeed Perform back feed after
completion of ECO.
ON Performed
(A fine adjustment value
for the stop position is
also printed.)
OFF Not performed
MODE1 Stops
forward feed.
MODE2 Stops after 6-mm back
feed and 3-mm forward
feed. (Only when the cut
mode, thermal transfer,
and feed gap sensor are
selected.) In other cases,
the printer stops after
13.7-mm forward feed.
ON Head-up operation is
performed, or the
rewinder is used.
OFF Head-up operation is not
performed,
rewinder is not used.
ON(TAG) Used when the head lever
position is "TAG"
ON(LBL) Used when the head lever
position is "LABEL".
OFF Not used
ON Pre-peel-off operation is
performed.
OFF Pre-peel-off operation is
not performed.
STD 3ips
LOW 2ips
OFF Auto calibration is not
preformed.
ON TRANS. Auto
performed
transmissive sensor.
ON REFLECT Auto
performed
sensor.
ON ALL Auto
performed
sensor.
ON Perform back feed after
TRANS.+Bfeed movement
TRANS.
EO18-33027
5.3 SELF-DIAGNOSTIC TEST
after 13.7-mm
or the
calibrating is
by
calibrating is
by reflective
calibrating is
by both
of ON