On Line Mode - Toshiba B-EX4 SERIES Maintenance Manual

6. ON LINE MODE

6. ON LINE MODE
In the ON LINE mode, the following settings can be performed.
Threshold Setting for the Feed Gap Sensor
Threshold Setting for the Black Mark Sensor
Reset
Parameter Settings
Printer Parameter Fine Adjustment
Dump Mode
LED function
ON LINE
ERROR
Key function
Key Function
[FEED] (1) Feeds one sheet of paper. This key can be used to eject one sheet of paper.
(2) Prints the data in the image buffer on one label according to the system mode
* For the following, refer to the parameter setting section.
* Feeds label even though there is label at peel off sensor in peel-off mode.
Indicates that the printer is in online condition.
Blinks that the printer is communicating with host.
Indicates that the printer is in error condition.
Blinks when ribbon is in near end condition.
Blinks when the system error occurs.
This key can also be used to adjust the paper to the proper position when the
paper is not properly positioned. If printing is attempted when the paper is not
properly positioned, printing is not performed at the proper position. One or two
sheets of paper should be fed to adjust the paper position before printing.
setting.
NOTE: A clear command or a command for drawing should not be sent during
printing by the [FEED] key. If it is sent, the correct layout will be lost, and the
label will not be printed properly. If an issue is performed by the [FEED] key while
the data is being drawn in the image buffer, the correct layout may be lost.
• The procedure for using the label having a label pitches of less than 38 mm in the
cut issue mode when the disk cutter is used.
• The procedure for using the label having less than the min. label pitch for each
issue speed in the cut issue mode when the rotary cutter is used.
6- 1
EO18-33027
6. ON LINE MODE