Table of Contents
Advertisement
To toggle between the Flashing LED
Transmitter. The parking lights will flash once slowly to indicate that the LED is active. If you press
and
LOCK
UNLOCK
now disabled.
Flashing LED ON: The LED will flash at all times (being passive or active arming) to denote
•
that the Starter Kill is active.
Active arming: the LED flashes normally.
Passive arming: the LED will flash at a faster rate during the countdown until the Unit
In Valet Mode: the LED will be on solid.
Flashing LED OFF: The LED will not flash when the module is armed (passive or active
•
Safe Start
If this feature is enabled, the user must press the
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
• To remote-start the vehicle if Swap Start Mode is selected, press
• The
output can be activated by pressing the
AUX 2
must have been configured in Menu 3, Feature 3
Engine Run Time
On a gas engine, the Remote Car Starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). On a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes by default).
Idle Mode
Convenience feature: Idle Mode allows the user to keep the engine running and the doors
locked while they stop, for example, at a convenience store or for a short delivery.
This feature allows the user to let the remote starter take over control of the vehicle (i.e. no Key in
the Ignition Switch) while the engine is running.
If the vehicle has an automatic transmission, proceed as follows to set the system to Idle
Mode:
1. With the engine running, make sure to release the brake pedal and press the
or
button on the transmitter until the parking lights come
START/STOP
2. Remove the ignition key from the ignition switch.
The engine will continue running.
3. Exit the vehicle and close all doors, hood and trunk.
4. Press the
LOCK
This will also arm the OEM-style alarm and starter kill (if configured).
5. Press the
UNLOCK
Note: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.
If the vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode (see "Ready Mode Option" in this Guide); at the last step, the
button is pressed instead of the other buttons.
TRUNK
Please note that the horn will honk once and that the OEM-style alarm will be armed if the
Idle Mode option is enabled.
Installation Guide
ON
once more, the parking lights will flash 3 times quickly to show that the LED is
is armed, at which time the flashing rate will slow down.
arming). However, if the module is in Valet Mode, the LED will remain
on solid when the Ignition is
button to leave the doors locked.
button to leave the doors unlocked.
and
, press
OFF
LOCK
.
OFF
START/STOP
START/STOP
(AUX 2).
and
simultaneously on the
UNLOCK
button twice within 3 seconds to
and then
F
button. The Option 1 or 2
LOCK
.
ON
.
LOCK
UNLOCK
,
P. 23
Hide quick links:
Advertisement
Table of Contents
