Table of Contents
Advertisement
• To arm the OEM-style alarm, press the
- The OEM-style alarm will ONLY arm if the
- The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now
armed.
• To disarm the OEM-style alarm, press the
- To stop the horn from sounding if the OEM-style alarm is triggered, press the
button, or put the system in and out of Valet Mode.
UNLOCK
Ready Mode Option
If the vehicle has a manual transmission, please read the following indications. In order to start
the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected. Therefore, you must follow the appropriate procedure between
the two described below in order to set the vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2.
With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. of engaging the parking
brake, press and hold
START/STOP
The parking lights will flash 3 times
quickly and remain lit.
4.
Remove the key: the engine will continue running.
5.
Exit the vehicle and close all doors, hood and trunk.
6.
Press for approx. 1 second either:
a.
LOCK
b.
UNLOCK
c.
START/STOP
Note: The vehicle will also enter Ready Mode once the engine run time expires.
Bypass
Remote starters of this series offer three possibilities for bypass D2D: they are compatible with
Trilogix, ADS and Fortin bypasses (Trilogix by default).
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same remote starter model, to
control both systems with a single remote control. To control the second vehicle, simultaneously
press the
button and the button of the function you wish to use:
TRUNK
P. 28
,
LOCK
UNLOCK
on the transmitter.
to lock the doors and shut down the engine;
to unlock the doors and shut down the engine;
to shut down the engine without affecting the doors.
button on the transmitter.
LOCK
button on the transmitter is pressed.
LOCK
button on the transmitter.
UNLOCK
If Ready Mode is enabled by handbrake
2.
With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
or
LOCK
IGNITION ON (RUN)
-
Installation Guide
or
Hide quick links:
Advertisement
Table of Contents
