Table of Contents
Advertisement
To take the system into home valet mode:
1.
Press the
2.
Within 3 seconds, press the
twice.
To take the system out of home valet mode:
•
Turn the ignition key to the IGNITION ON (RUN) position.
The system will warn you if someone attempts to start your vehicle while it stands in home valet
mode. The parking lights will: Turn
Safe Start
This feature will eliminate accidental remote starts, e.g. when children are playing with the
transmitter.
1.
Safe start enabled: If this feature is enabled, the user must press the
3 seconds to remote-start the vehicle.
2.
Swap start: If this feature is enabled;
a.
b.
c.
The AUX 2 output can be activated by pressing the
Engine Run Time
On a gas engine, the Remote Car Starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). On a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes by default).
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:
1.
With the engine running, make sure to release the brake pedal and press the
button on the transmitter until the parking lights come
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode (page-22); at the last step, the
other buttons. This will lock the doors, arm the system and leave the engine running.
Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.
Note2: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Installation Guide
or
button.
then
ON
Press and release the AUX button.
The
button on the transmitter will light up.
While the
is lit up, press
button to lock the doors, to arm the starter kill and to arm the alarm.
and
buttons simultaneously until the remote beeps
; then, flash twice, pause; then, flash twice again.
OFF
to remote start the car.
button.
button twice within
.
ON
button is pressed instead of the
or
,
P. 25
Hide quick links:
Advertisement
Table of Contents
