Table of Contents
Advertisement
Quick Links
A U T O M A T I C T R A N S M I S S I O N R E M O T E S T A R T E R
S Y S T E M
AS-6205 SH
Installation Guide
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of the product, be that either damage to the vehicle itself or to the
Unit. This Unit must be installed by a certified technician using all safety devices
supplied. Please note that this guide has been written for properly trained Autostart
technicians, a certain level of skill and knowledge is therefore assumed. Please review
the Installation Guide carefully before beginning any work.
Warning
automatic
This unit is designed for vehicles with an
Transmission only.
Before installing the Unit, test that the vehicle will not start if the gear select lever is in the
"Drive" position. If the vehicle starts in gear, install a manual-transmission Car Starter
instead.
H.310 S.3.20
DOC: 1.00
CA –
September 15, 2003
Manufactured in Canada by Autostart
Advertisement
Table of Contents
Related Manuals for Autostart AS-6205 SH
Summary of Contents for Autostart AS-6205 SH
-
Page 1: Installation Guide
Unit. This Unit must be installed by a certified technician using all safety devices supplied. Please note that this guide has been written for properly trained Autostart technicians, a certain level of skill and knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work. -
Page 2: Table Of Contents
Events Logging... 18 Events playback ... 18 Start Failure Codes via Parking Lights... 18 Intrusion Codes ... 19 Intrusion Codes via LED light ... 19 Chirps ... 19 Diagnostics - Parking Lights Flash Rate ... 20 Installation Guide AS-6205 SH... -
Page 3: Introduction
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. AS-6205 SH Installation Guide 1 – five-pin 18 AWG Harness (Main Harness) 1 –... -
Page 4: Before You Get Started
“clicks” per flash, 1 click for ON and 1 click for OFF). Parking Light flashes referred to in this manual refer to the Parking Light output of the Module and not that of the vehicle. Installation Guide AS-6205 SH... -
Page 5: 6-Pin Main Ignition Harness
Camshaft sensor, Crankshaft sensor or the Engine Control Module (ECM). input NOTE: A Tach signal that is too low will cause the Module to “over crank” and a Tach signal that is too high will cause the Module to AS-6205 SH Installation Guide Description switch). The source IGNITION position only. -
Page 6: 12-Pin Accessories Harness
Connect this wire to the Hood Pin-switch supplied. This input will disable or (-) Hood shut down the Remote Starter when the Hood is opened. It is also used for Switch programming and therefore it is essential that it is installed. - Page 7 Doors to turn off Ready Mode: the driver-side Door Pin does not constitute by itself a sufficient connection. AS-6205 SH Installation Guide position (The Starter Kill CRANK button is pressed, etc.). The...
-
Page 8: 2-Pin Harness
Combustion Chamber before the vehicle is started. When a Remote Starter is installed on a diesel vehicle, the Glow- plug section of the Ignition circuit must be activated and allowed to operate before the vehicle is remote-started. -
Page 9: Flashing The Hood Pin
Failure to do so will result in the Module exiting the Programming Centre and you will have to Flash the Hood Pin once more. AS-6205 SH Installation Guide before the end of that cycle, at which point, the UNLOCK function programming. -
Page 10: The Programming Assistance Button (A.k.a. Pab.)
Hood-Pin switch in order to avoid having to get out of the vehicle and pressing the Hood-Pin switch. The PAB will work only when the Hood is up. position. IGNITION ON (RUN) Table 1 Table 2 Installation Guide AS-6205 SH... -
Page 11: Options Programming
OPTION 3 Constant output while pressed (press Car Finder disabled. OPTION 4 Priority Door access on 2 The Driver’s door unlocks upon the 1 AS-6205 SH Installation Guide Option 1, Option 2, Option 3, or Option 4. Table 3 ONLY... - Page 12 Shock Sense - Ignored / Warn Away – monitored Function 5 – Ignition Valet OPTION 1 Ignition Valet - DISABLED P.12 … pressing of the UNLOCK button to activate AUX 2 Diesel mode. button is press 2nd time. LOCK TWO-STAGE DISARM Installation Guide AS-6205 SH button.
-
Page 13: Horn Honk / Siren Timing (Optional)
Tach signal is detected. Press and hold the Brake Pedal until the Parking Light output from the Module flashes 5 times. Turn the Ignition . At this point, the Tach setting has been programmed. AS-6205 SH Installation Guide button. LOCK START button. -
Page 14: Multi-Speed Tach Programming
Remote-start the Engine and listen for Starter drag. If the Starter cranks for too long, carry out another Tach learning procedure. Test Hood Switch shutdown: with the vehicle running under the Remote Starter, open the Hood; the vehicle should shut down. If it does not shut down, check the Hood Pin-switch and its connector. -
Page 15: Closing Up
Fifth Relay Output (2 IGN or 2 This Remote Starter is equipped with a high-current programmable 5th relay onboard that can be used to power a second Ignition, Accessory, or Start wire. The Unit uses a series of jumpers; each set of jumper pins represents a function. In order to... -
Page 16: Ignition-Controlled Door Locks
Starter wire for amperage when vehicle is cranking. position and the IGNITION ON (RUN) Table 7 LOCK wires and the DISARM wires. UNLOCK the Doors. LOCK STOP pulse preceding start-up. The system will Table 8 Installation Guide AS-6205 SH UNLOCK button), LOCK... -
Page 17: Safe Start (Child Safety Mode)
Option 2: Passive Mode: the system will arm itself unless remote-armed within 30 sec. Press to disarm. UNLOCK Option 3: Passive Mode without Two-Stage Disarm: Press Option 4: Active Mode with Disarmed Notification. AS-6205 SH Installation Guide button on the Transmitter twice START buttons simultaneously. LOCK UNLOCK AUX2. -
Page 18: Disarmed Notification
– but without unlocking or UNLOCK button. TRUNK Table 12 4 x = Brakes 5 x = No Tach cut-off 6 x = Hood 7 x = Engine Running, no Ignition detected, or Tach before Start Installation Guide AS-6205 SH... -
Page 19: Intrusion Codes
Alarm condition generated by an intrusion, by triggering Panic Mode, or Constant up to when the Module is powered up. 60 seconds AS-6205 SH Installation Guide Intrusion Codes 1 x = Power-up Reset: Battery disconnected / reconnected or dead…... -
Page 20: Diagnostics - Parking Lights Flash Rate
If the Module gives irregular flashes (1 to 10 flashes followed by a pause, followed Irregular by more flashes), it is in Playback Mode. This occurs when the Hood-switch line is flashed 3 times. Constant Panic Mode set off. flashes up to 30 sec. P.20 Description button under Safe Start. Installation Guide AS-6205 SH...