Remote Door Locks; Priority Door Access; Active Or Passive Arming; The Starter Kill And The Anti-Grind Feature - Autostart AS-2300TW User Manual

Remote Door Locks

If your remote starter was installed with the remote door locks option, you will have the
convenience of remote keyless entry. See section Arming and Disarming the Remote Starter,
on page 8, for further instructions on remote door locking and unlocking.

Priority Door Access

If the remote door locks option is installed on your vehicle, this safety feature allows you unlock
solely the driver's door with a single press of the
press of the button, all the other doors will unlock.
UNLOCK

Active or Passive Arming

The starter kill can be configured either to passive mode (so as to arm automatically) or active
mode (so as to require user intervention for arming). By default, your remote starter is configured to
passive mode. In passive mode, the starter kill will automatically arm 60 seconds after the last
door is closed. The remote starter will not arm if a door is left open, or if you re-open a door within
the 60-second delay.
Important note: When the remote starter re-arms automatically, you can disarm the When
the remote starter by simply pressing the

The Starter Kill and the Anti-grind Feature

With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the starter kill is armed. If your remote starter was installed with the starter kill option,
one will not be able to start your vehicle with the key unless the system has been unlocked and
disarmed first, or put into valet mode.
Note: If the starter kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the

Flashing LED

The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press
and hold the and
LOCK
holding the buttons pressed until you hear another beep. At that point release the buttons. The
LED will toggle to its next state –i.e.: ON/OFF:
There are three programmable options regarding the flashing LED:
i. The LED flashes once the starter kill is activated (passive or active arming) and will
turn itself off once the user turns the key to the
ii. The LED is totally disabled and will not flash –it will turn on solid, however, when in
valet mode.
iii. The LED will flash once the starter kill is activated but requires pressing the
button to turn itself off. Failure to press the
even if the key is in the

Safe Start

If this feature is enabled, the user must press the
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
If swap start mode is selected, to remote-start your vehicle, press the
button. The
LOCK AUX 2
Home Valet TM
If this feature is installed, the user will have the possibility to remotely set the vehicle to a no-
remote-start mode. See home valet section, on page 10, for full instructions.
P. 12
UNLOCK
position.
CRANK
buttons on the transmitter. There will be an initial beep. Keep
UNLOCK
IGNITION ON
output can be activated by pressing the
button on the transmitter; upon a second
UNLOCK
button.
IGNITION ON
button will make the LED flash
UNLOCK
position.
button 2 times within 3 seconds to
START/STOP
START/STOP
User Guide AS-2300TW
position.
UNLOCK
button and then the
SHIFT
button.