Programming Options - Autostart AS-3472TW-FM Installation Manual

2. Before the lights go out, press and hold the brake pedal and then press one of the following
buttons:
3. The parking lights will flash and the horn will honk (if programmed) once, twice, three or four
times to confirm entry into a menu.
4. Release the brake pedal.
Once the desired menu has been selected, the unit will fall (by default) into feature #1 of that
menu; you can now select the option you want in feature 1. Once this option has been chosen, the
unit will move on to feature 2 of the menu selected, and so on.

Programming Options

MENU 1
FEATURE 1 – Ignition-controlled door locks
OPTION 1*
OPTION 2
OPTION 3
OPTION 4
FEATURE 2 – Secure Lock
OPTION 1*
OPTION 2
OPTION 3
FEATURE 3 – Starter kill arming mode
OPTION 1*
OPTION 2
OPTION 3
FEATURE 4 – Door lock / unlock pulse timing
OPTION 1*
OPTION 2
OPTION 3
OPTION 4
FEATURE 5 – LED flashing
OPTION 1*
OPTION 2
OPTION 3
MENU 2
FEATURE 1 – Safe Start
OPTION 1
OPTION 2*
OPTION 3
FEATURE 2 – Engine Run Time
OPTION 1
OPTION 2*
OPTION 3
FEATURE 3 – Idle Mode & Turbo Mode (auto) / Turbo Mode (manual)
OPTION 1
OPTION 2*
OPTION 3
FEATURE 4 – Engine type and Cold Weather Mode
OPTION 1
OPTION 2*
OPTION 3
OPTION 4
Installation Guide
...............................to access menu 1;
LOCK
...........................to access menu 2;
UNLOCK
........................ to access menu 3; or
TRUNK
...................to access menu 4.
START/STOP
LOCK
UNLOCK
TRUNK
START/STOP
* INDICATES DEFAULT SETTING
Ignition lock
DISABLED
Ignition lock
ENABLED
Ignition unlock only
Ignition lock only
Secure lock
DISABLED
Standard secure lock
Smart secure lock
ENABLED
Passive arming (60 sec.)
Active arming
Passive arming (3 min.)
7/10-sec. lock / unlock pulses
4-sec. lock / unlock pulses
7/10-sec. lock pulse and two 1/4-sec. unlock pulses
1/10-sec. lock / unlock pulses
(without starter kill
ENABLED
DISABLED
(with starter kill
ENABLED
This option should be selected ONLY if the starter kill is installed.)
* INDICATES DEFAULT SETTING
Safe Start
ENABLED
Safe Start
DISABLED
"Swap Start" – enhanced safe start mode with extended safety: To start the engine: press
F then buttons. To trigger
LOCK
Run Time = 3 minutes in gas mode / 8 minutes diesel mode
Run Time = 15 minutes in gas mode / 20 minutes diesel mode
Run Time = 25 minutes in gas mode / 30 minutes diesel mode
Idle mode & turbo mode
Idle mode & turbo mode
Idle mode & turbo mode
Diesel mode with 20-minute run time in cold weather mode (30-sec. wait to start delay)
Gas mode with 3-minute run time in cold weather mode
Diesel mode with 8-minute run time in cold weather mode (18-sec. wait to start delay)
Diesel mode with 8-minute run time in cold weather mode (7-sec.wait to start delay)
for Option 1,
for Option 2,
for Option 3;
for Option 4.
ENABLED
will flash only when ignition is OFF)
will flash when the starter kill engages.
: press
AUX 2 START/STOP
/ turbo mode
DISABLED (AUTO)
/ turbo mode
ENABLED (AUTO)
/ turbo mode
ENABLED (AUTO)
button.
DISABLED (MANUAL)
DISABLED (MANUAL)
ENABLED (MANUAL)
P. 17