Ignition Re-Lock; Secure Lock; Key Sense Option; Remote Trunk Release - Autostart PD-2.7 User Manual

Ignition Re-lock

On Remote Car Starters of this series, when Ignition-controlled Door Locks are enabled and the
ignition key is in the
will be relocked next time the brake pedal is pressed.

Secure Lock

(Disabled by default.) Before it can remote-start your vehicle, the Remote Car Starter must first
disarm the factory security system. The Secure Lock feature may be required on certain vehicle
models with factory security systems that automatically unlock the doors when the security system
is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, Secure Lock will rearm your factory security system.

Key Sense Option

If your system is installed with Key Sense, when in Passive Mode the Starter Kill will not rearm if
the ignition key is detected in the ignition switch. Likewise, Secure Lock will not lock nor rearm your
vehicle when the ignition key is detected in the ignition switch.

Remote Trunk Release

If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
TRUNK
disarmed until the
LOCK

The Starter Kill and the Anti-grind Feature

With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the Starter Kill is armed. If your Remote Car Starter was installed with the Starter Kill
option, one will not be able to start your vehicle with the key unless the system has been unlocked
and disarmed first, or put into Valet Mode.
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the

Safe Start

If this feature is enabled, the user must press the
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
If Swap Start Mode is selected, to remote-start your vehicle press
simultaneously. The

Installer-programmable Valet Modes

Valet Mode Using the Valet Switch

When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o Valet Mode:
1. Turn the ignition key to the
2. Within 3 sec., press the valet button. The parking lights will flash 3 times.
3. Turn the ignition key to the
4. The L.E.D. will come
To take the system o u t o f Valet Mode:
1. Turn the ignition key to the
2. Within 3 sec., press and release the valet button.
P. 8
position, should any door be unlocked and opened, all doors
IGNITION ON (RUN)
button for 3 seconds on the remote transmitter.
button is pressed.
CRANK
output can be activated by pressing the
AUX 2
IGNITION ON (RUN)
IGNITION OFF
solid indicating that the vehicle is now in valet mode.
ON
IGNITION ON (RUN)
position.
START/ STOP
position.
position.
position.
The OEM alarm will be
button 2 times within 3 seconds to
LOCK
button.
START/ STOP
and
UNLOCK
User Guide