Table of Contents
Advertisement
Please note that most OEM systems will not rearm the alarm while the engine is running, but will
lock the doors.
Smart Secure Lock:
If the vehicle was previously locked with the remote starter transmitter, at remote start the module
will send an unlock/disarm pulse before start-up, lock/arm when the engine is running, and
lock/arm once again 4 seconds after it shuts down the engine.
If the vehicle is initially unlocked, upon remote start the module will start the engine and arm the
starter kill, but the doors will not be locked or unlocked at any moment of the sequence.
Starter Kill Arming Mode
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user's intervention for arming). By default, the
Remote Car Starter is configured to Passive Mode.
Passive mode:
• To arm the Starter Kill, press the
• In Passive Mode, the Starter Kill will also automatically arm 1 minute (by default) or 3 minutes
(if configured this way) after the ignition is turned
doors are monitored).
- The LED on the antenna will flash quickly during the countdown preceding the
activation of the Starter Kill.
- Once the activation countdown expires, the LED will send a series of quick double
flashes to indicate that the Starter Kill is now armed.
• To disarm the Starter Kill, press the
- The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes
(if configured this way) if no door is left opened (if the doors are monitored) and the
ignition is not turned
Active Mode:
• To arm the Starter Kill, press the
- The parking lights will flash once.
- The LED on the antenna will flash slowly.
- If remote door locks are installed, this will also lock the doors and arm the OEM-style
alarm.
• To disarm the Starter Kill, press the
- The parking lights will flash twice.
- The LED on the antenna will remain
- If remote door locks are installed, this will also unlock the doors.
Lock Pulse Duration
•
Option 1:
•
Option 2:
•
Option 3:
•
Option 4:
Flashing LED
To gain access to this feature, make sure the Flashing LED option has been enabled at the time of
programming. Once this option is enabled, the user has the choice to toggle the Flashing LED
and
at any given moment.
OFF
P. 22
button on the transmitter, OR
LOCK
UNLOCK
.
ON
button on the transmitter.
LOCK
UNLOCK
OUT
7/10-sec.
and 7/10-sec.
LOCK
4-sec.
LOCK/UNLOCK
A single 7/10-sec.
LOCK
Used for double-pulse Disarm/Unlock systems
1/10-sec.
and 1/10-sec.
LOCK
or once the last door is closed (if the
OFF
button on the transmitter.
button on the transmitter.
.
pulses by default.
UNLOCK
pulses.
pulse and two ¼-sec.
pulses.
UNLOCK
pulses.
UNLOCK
Installation Guide
ON
Hide quick links:
Advertisement
Table of Contents
