Table of Contents
Advertisement
Manual or Automatic Transmission
This module may be installed on vehicles with manual or automatic transmissions. It is originally
configured for manual transmissions. If the vehicle you are working on is automatic, it is mandatory
to make a few quick and easy modifications before the unit is connected. In the event that the
configuration requires changes afterwards, a complete reset will be necessary before those
changes become effective.
To install this unit in a vehicle with a manual transmission:
1.
Make sure the Yellow loop on the PC board is connected.
2.
Connect the Black/White handbrake wire located on the 12-pin harness to the vehicle
handbrake switch.
3.
Connect the Violet (+) door input OR the Green (-) door input wire located on the 12-pin
harness to the vehicle door pin wire, which monitors all the doors of the vehicle (only
use 1 of the 2 door trigger inputs).
4.
Make sure the Violet/White TACH wire is plugged in – the TACH wire MUST be hooked
up when the module is set for a manual transmission.
5.
Make all your regular connections.
6.
Power up the unit by first inserting the 5-pin connector, then the 6-pin connector and
finally the 12-pin connector. The parking lights will flash 4 times to confirm that the unit
is in manual mode.
7.
When learning the transmitter, the parking lights will flash 5 times quickly, confirming
that the module is set to manual mode.
8.
Upon the first successful remote start, the system will lock the transmission
settings to manual mode.
To install this unit in a vehicle with an automatic transmission:
1.
Cut the loop on the pc board (Yellow wire).
2.
Make sure the Black/White handbrake wire is not connected to any of the vehicle
circuits.
3.
Make all the regular connections.
4.
Power up the unit. The parking lights will flash 4 times.
5.
When learning the first transmitter, the parking lights will flash 5 times quickly then give
2 slow flashes, confirming that the module is set to automatic mode.
6.
Upon the first successful remote start once the yellow loop has been cut, the
system will lock the transmission settings to automatic mode.
Note: If upon pressing the
that the Black/White handbrake wire is not connected and that the yellow loop is cut and isolated.
Transmitter Programming Procedure
1. Enter programming mode (see on page 15) the parking lights will stay on for up to 20
seconds.
2. Before the lights go out, turn the ignition key to the
immediately back to the
3. Press and hold the
4. The transmitter has been stored in memory.
Note: Each unit can store 4 remotes in its memory.
To program a transmitter on the second vehicle for multi-car operation, you must press the
button (instead of
TRUNK
Entering Programming Options
1. Enter programming mode (see on page 15) the parking lights will stay on for up to 20
seconds.
P. 16
button, the parking lights give 3 slow flashes, make sure
START/STOP
position.
OFF
button and keep it down until the parking lights flash 5 times quickly.
LOCK
or
LOCK
UNLOCK
position, then to
OFF
) in step 3 of the transmitter programming procedure:
and
IGNITION ON (RUN)
Installation Guide
Hide quick links:
Advertisement
Table of Contents
