Table of Contents
Advertisement
Passive or Active Arming
Starter Kill / Anti-grind feature
Horn Chirp Timing
Safe Start
Home Valet
TM
Ignition-controlled Door Locks
Remote Door Locks
If your remote starter was installed with the remote door locks option, you will have the
convenience of remote keyless entry. See section Arming and Disarming the Remote Starter,
on page 8, for further instructions on remote door locking and unlocking.
Priority Door Access
If the remote door locks option is installed on your vehicle, this safety feature allows you unlock
solely the driver's door with a single press of the
press of the
button, all the other doors will unlock.
UNLOCK
Active or Passive Arming
The starter kill can be configured either to passive mode (so as to arm automatically) or active
mode (so as to require user intervention for arming). By default, your remote starter is configured to
passive mode. In passive mode, the starter kill will automatically arm 60 seconds after the last
door is closed. The remote starter will not arm if a door is left open, or if you re-open a door within
the 60-second delay.
Important note: When the remote starter re-arms automatically, you can disarm the When
the remote starter by simply pressing the
The Starter Kill and the Anti-grind Feature
With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the starter kill is armed. If your remote starter was installed with the starter kill option,
one will not be able to start your vehicle with the key unless the system has been unlocked and
disarmed first, or put into valet mode.
Note: If the starter kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the
Flashing LED
The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press
and hold the
and
LOCK
holding the buttons pressed until you hear another beep. At that point release the buttons. The
LED will toggle to its next state –i.e.: ON/OFF:
There are three programmable options regarding the flashing LED:
i.
The LED flashes once the starter kill is activated (passive or active arming) and will
turn itself off once the user turns the key to the
ii.
The LED is totally disabled and will not flash –it will turn on solid, however, when in
valet mode.
iii.
The LED will flash once the starter kill is activated but requires pressing the
button to turn itself off. Failure to press the
even if the key is in the
Safe Start
If this feature is enabled, the user must press the
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
AS-2300TW Guide d'installation
UNLOCK
position.
CRANK
buttons on the transmitter. There will be an initial beep. Keep
UNLOCK
IGNITION ON
Turbo Mode
Remote Trunk Release
Engine Run Time
Extended run time
Multi-car Operation
button on the transmitter; upon a second
UNLOCK
button.
IGNITION ON
button will make the LED flash
UNLOCK
position.
button 2 times within 3 seconds to
START/STOP
position.
UNLOCK
P. 11
Advertisement
Table of Contents
