Table of Contents
Advertisement
5
Pager Port
Entering Programming Mode
This allows the installer to program the unit. Once the system is in programming mode, the installer
will have up to 20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu
before the 20-second delay, the system will exit programming mode and the installer will have to
select again one of the 2 methods to get access to it.
Using the Hood Pin
• Press and hold the hood pin for 4 seconds.
• Release the hood pin.
The parking lights will turn
• While the parking lights are
pin once more and release immediately.
The parking lights will turn
20 seconds.
• You now have 20 seconds to select one of the
sub-menus.
Note: To exit programming mode, close the hood.
Remember: You can use the programming Assistance button instead of the
hood pin at any time the hood is up.
The Programming Assistance Button (a.k.a. PAB)
Once inside the programming options, the installer has a selection of many different sub-menus:
Installation Guide
Is used to connect an optional AS-200P pager (to use this option, make sure to program
pager option in Menu 3, Feature 5, Option 4).
.
ON
, press the hood
ON
and stay
ON
ON
a)
Transmitter Programming
b)
Programming Options
c)
Honk Horn Timing* (*if available)
d)
Tach Programming
Using the Antenna Programming Assistance
• Make sure that the hood is closed.
• Turn the ignition key to the
position.
• Within 5 seconds, press the programming button
on the antenna twice for 1 second each time.
for
The LED will come
• You now have 20 seconds to select one of the
sub-menus.
Note: To exit programming mode, press on the
antenna button once (the LED will come
release.
Button (A.P.A.B.)
IGNITION ON (RUN)
solid.
ON
The PAB is located
on the side of the
module.
This push
button
mimics
hood-pin switch in
order to avoid having
to get out of the
vehicle and pressing
the hood-pin switch.
The PAB will work
only when the hood
is up.
) and
ON
the
P. 15
Hide quick links:
Advertisement
Table of Contents
