Diagnostics - Parking Light Flash Table - Autostart AS-3472TW-FM Installation Manual

Diagnostics – Parking Light Flash Table
Flashes
1
2
2 slow flashes then
8 quick flashes
3
3 Slow
(automatic transm.)
4
5 Fast
6
8
10
1 – pause – 2
ON SOLID for 3
seconds....
ON continuously
ON 2 seconds
ON 4 seconds
ON 20 seconds
Continuous flashes
25 seconds
Continuous flashes
60 seconds
P. 34
• Doors locked, starter kill armed.
• Run time has expired.
•
button pressed.
TRUNK
• Doors unlocked, starter kill disarmed.
• Remote start attempt cancelled by remote.
• Exiting ignition valet.
• Exiting remote valet.
• Reset from Manual to Automatic
• Entering cold weather mode.
• Extended run time.
• Parking brake is engaged
• +12 V detected on the brake input wire either while cranking or during run time.
• Entering multi-speed tach programming.
• Entering time delay adjustment in virtual tach system
• Board set from automatic to manual; power ON.
• Power ON to OFF (manual transmission).
• Tach signal programmed.
• New transmitter programmed
• A remote start was attempted while a tach-before-crank signal was detected before cranking.
• Unit reset; see "Resetting the Module".
• A ground (-) signal was detected on the hood pin input wire.
• There was a remote start attempt while the vehicle was in valet mode.
• Failed start: vehicle's low battery voltage.
...followed by 1 flash
...followed by 3 flashes
• Idle mode: Idle mode is engaged
• Run time: The vehicle has been remote started and is in run time.
• The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire.
• Locking or unlocking a door (with Door pulses configured to 4 sec.)
• The hood pin has been flashed and you are now in the programming centre.
• Panic mode is activated.
• OEM alarm triggered (Honk)
Description
• Start signal received by the module.
• Cold weather mode cancelled.
• Power-up reset.
• Board set from manual to automatic; power
ON.
• Power ON to OFF (automatic transmission).
• Entering ignition valet.
• Entering remote valet.
• Yellow loop has been reconnected
Exiting cold weather mode
Entering cold weather mode
Installation Guide