3-Pin Harness; Additional Ports - Autostart AS-3472TW-FM Installation Manual

3-pin Harness

Wire
VIOLET/BLACK
1
(-) AUX 2 Output
LIGHT BLUE
2
(-) AUX 1 Output
WHITE/BLACK
3 (–) Parking lights
output

Additional Ports

Port
Temperature
1 Sensor
(Optional)
2 RS-232 Port
3 INV-200 Port
4 Bypass/GPS Port
P. 14
vehicles is to pre-heat the Combustion Chamber before the vehicle is started.
When a Remote Starter is installed on a diesel vehicle, the Glow- plug section of the
Ignition circuit must be activated and allowed to operate before the vehicle is remote-
started. For that purpose, the Glow-plug input wire of the module must be connected to
the Glow-plug indicator light of the vehicle. The module will only accept positive Glow-plug
input signals, if the signal is negative, use a relay to invert its polarity. A diode must be
added between the negative Glow-plug trigger on the relay and the negative Glow-plug
wire of the car. This is to prevent feedback effects on the Glow-plug indicator light on the
instrument cluster: the light on the dash would come on because of the feedback, even
though the circuit is off.
When the user remote-starts the vehicle:
The module will power up the Ignition circuit and wait to engage the Starter Motor while
the Glow-plug indicator light is still on.
The module will engage the Starter Motor as soon as the Glow-plug light (+) goes out.
Minimum waiting time is 3 seconds.
Maximum waiting time is 30 seconds (approximately).
If no Glow-plug wire is found on the vehicle, the Glow-plug input on the module may be
"timed out". The module will power up the Ignition and Glow-plug circuits and simply wait
for the time-out before starting.
Keeping the Glow-plug input wire of the module unconnected will hold the ignition
the preprogrammed delay.
Please program the tach before connecting the glow-plug input to the vehicle.
500 mA negative output. Can be programmed for one of the following four options:
1. Constant while the
buttons are released.
2. Pressing the
LOCK
for up to 30 sec.
ON/OFF
3. Pressing the
LOCK
for up to 4 min. (active only when under remote run).
ON/OFF
4. Priority door access. Produces a (-) pulse on the 2
500 mA negative output. Can be programmed for one of the following three options:
1. Horn confirmation on the 2
2. Priority door access. Produces a (-) pulse on the 2
3. Horn confirmation on 1
500 mA negative Parking Light output
Note: Ensure that the voltage does not vary when the dimmer control switch is turned up
or down. If this is the case, it is not the right wire.
There is also a positive Parking Light output. Only one of these two different
outputs needs to be connected.
Is used to plug in the optional temperature sensor; allows remote temperature readout.
For D2D connection; is used to interface bypasses and door locks convenience module
(check bypass list for compatibility and functionalities).
Is used to interface the pulse inverter for door locks option.
Is used for analog connection to some bypass units (check bypass list for
compatibility and functionalities).
Description
and buttons are pressed, + 1 sec. after the
LOCK UNLOCK
+ buttons simultaneously will toggle the
UNLOCK
+ buttons simultaneously will toggle the
UNLOCK
press of the
nd LOCK
press of the
st LOCK
Description
press of the
nd UNLOCK
button.
press of the
nd UNLOCK
button.
Installation Guide
for
ON
output
AUX 2
output
AUX 2
button.
button.