12-Pin Accessories Harness - Autostart AS-1725 SH Installation Manual

12-Pin Accessories Harness

Wire Colour Function
(–) Trunk /
1 BLUE
AUX 3
(–) Lock
2 BROWN
output
(–) Unlock
3 GREEN
output
WHITE / (–) Rearm
4
BROWN output
WHITE / (–) Disarm
5
GREEN output
BLUE / (–) AUX 1
6
WHITE output
(–) Starter Kill
WHITE /
7 output
ORANGE
(armed output)
(–) AUX 2
8 ORANGE
output
P. 6
500 mA negative output. This output can be used to control the
Trunk release (1-sec. pulse), or it can be set to operate as a
output constant output as long as the
Sunroof or Window closure)
Programmable 500 mA negative output: 1/10-sec., 7/10-sec. or 4-
sec. pulse
Programmable 500 mA negative output: 1/10-sec., 7/10-sec., 4-
sec. or double 1/4-sec. pulse (
500 mA ground signal when the Doors are locked by remote
control. This wire will go to ground 1/2 sec. before the
and go out 1/8 sec after
OEM Arm wire (usually the Door Pin).
Note: The Remote Car Starter will also give a Rearm pulse on this
wire when it shuts down the vehicle after a remote start.
500 mA ground pulse when the Doors are unlocked by remote
control. Connect to the OEM Disarm wire of the vehicle.
Note: The system will also give a Disarm pulse on this wire before
every remote start.
Depending on the configuration of Mode 3, Function 4 (see
Programming Options later in this Guide), this output will provide
either a 500 mA ground output on the 2
button for Priority Door Access, or a Horn Confirmation on
UNLOCK
the first or second press of the
This wire will provide a constant 500 mA output when the system is
armed (locked by remote control). It can be connected to an
external Starter Interrupt Relay.
This wire should be connected to a Single Pole Double-Throw
Relay: this wire will connect to Pin 85 on the Relay, and Pin 86 will
be connected to the Ignition wire.
The Starter Kill output becomes active during remote starts.
One benefit of the Starter Kill is the Anti-Grind feature. Once the
vehicle has been remote started, the Anti-Grind prevents the
Starter Motor from re-engaging when the Ignition Key is inserted in
the Ignition Switch and accidentally turned to the
This negative 500 mA output can be programmed for one of the
following options:
1. Constant while the
sec after release of the buttons.
2. + toggles
LOCK UNLOCK
3. + toggles
LOCK UNLOCK
4. Priority Door Access (2
Description
button is held pressed (for
TRUNK
250 ms, 500 ms,
ON OFF ON
LOCK
. The wire must be connected to the
LOCK
nd consecutive press of the
button.
LOCK
position.
CRANK
and buttons are pressed + 1
LOCK UNLOCK
(max. 30 sec.).
ON / OFF
(max. 60 sec.).
ON / OFF
nd press of )
UNLOCK
Installation Guide AS-1725 SH
250 ms).
pulse,