12-Pin Accessories Harness - Autostart as2520 Installation Manual

12-Pin Accessories Harness

Wire Colour Function
(–) Trunk /
1 BLUE
AUX 3
(–) Lock
2 BROWN
output
(–) Unlock
3 GREEN
output
WHITE / (–) Rearm
4
BROWN output
WHITE / (–) Disarm
5
GREEN output
BLUE / (–) AUX 1
6
WHITE output
(–) Starter kill
WHITE /
7 output
ORANGE
(armed output)
(–) AUX 2
8 ORANGE
output
P. 6
500 mA negative output. This output can be used to control the
trunk release (1-sec. pulse), or it can be set to operate as a
output constant output as long as the
(for sunroof or window closure)
Programmable 500 mA negative output: 1/10-sec., 7/10-sec. or
4-sec. pulse
Programmable 500 mA negative output: 1/10-sec., 7/10-sec.,
4-sec. or double 1/4-sec. pulse (
250 ms).
500 mA ground signal when the doors are locked by remote
control. This wire will go to ground 1/2 sec. before the
pulse, and go out 1/8 sec after
connected to the OEM arm wire (usually the door pin).
Note: The module will also give a rearm pulse on this wire
when it shuts down the vehicle after a remote start.
500 mA ground pulse when the doors are unlocked by remote
control. Connect to the OEM disarm wire of the vehicle.
Note: The system will also give a disarm pulse on this wire
before every remote start.
Depending on the configuration of Mode 3, Function 4 (see
programming options), this output will provide either a
500 mA ground output on the 2
button to unlock all doors, or a horn confirmation on
UNLOCK
the first or second press of the
This wire will provide a constant 500 mA output when the
system is armed (locked by remote control). It can be
connected to an external starter interrupt relay.
This wire should be connected to a single pole double-throw
relay: this wire will connect to pin 85 on the relay, and pin 86
will be connected to the ignition wire.
The starter kill output becomes active during remote starts.
One benefit of the starter kill is the anti-grind feature. Once the
vehicle has been remote started, the anti-grind prevents the
starter motor from re-engaging when the ignition key is
inserted in the ignition switch and accidentally turned to the
position.
CRANK
This negative 500 mA output can be programmed for one of
the following options:
1. Constant while the
pressed + 1 sec after release of the buttons.
2. +
FUNCTION LOCK
3. +
FUNCTION LOCK
Only when running under a remote start).
4. Priority door access (2
other doors). Refer to Priority Door section on page 17
for more detail.
Description
button is held pressed
TRUNK
250 ms, 500 ms,
ON OFF
. The wire must be
LOCK
nd consecutive press of the
button.
LOCK
and buttons are
FUNCTION LOCK
toggles (max. 30 sec.).
ON / OFF
toggles (max. 4 minutes
ON / OFF
nd press of to unlock all
UNLOCK
Installation Guide
ON
LOCK