Table of Contents
Advertisement
Note: The parking light output relay of
the unit gives two clicking sounds for
each flash of the lights: one click when
the lights would go
when the lights would go
Harness Description
When connecting a module, it is important to make sure that the connector with the
ground wire is connected first, before making the 12-volt connections. Should the unit be
powered up before being grounded, there could be serious damage to internal
components of the unit.
B e c a r e f u l n o t t o p o w e r u p a m o d u l e b e f o r e i t i s p r o p e r l y
g r o u n d e d . To avoid any accident, it is recommended to pull out the fuses from their
sockets before the installation, and to put them back during the very last steps.
6-Pin Main Ignition Harness
Wire
Colour
A
RED
B
PURPLE
C
RED
D
YELLOW
AS-2360TW Installation Guide
and one click
ON
.)
OFF
Function
Connect to the largest 12 V supply wire at the ignition
harness. Ensure that the OEM power wire is fused for
more than 30 A.
(+) 12 V
Please note: some of the most recent vehicles have
Battery
no suitable 12 V source at the ignition switch (the
12 V wire is too small to supply the necessary
current). In such cases, it is recommended to use the
fuse box or the B+ connection on the battery.
(+) Starter
Connect to the starter wire of the vehicle. The source
output
wire should have +12 V with the ignition key in the
(30 A)
CRANK
Connect to the largest 12 V supply wire at the ignition
harness. Ensure that the OEM power wire is fused for
more than 30 A.
(+) 12 V
Please note: some of the most recent vehicles have
Battery
no suitable 12 V source at the ignition switch (the
12 V wire is too small to supply the necessary
current). In such cases, it is recommended to use the
fuse box or the B+ connection on the battery.
Connect to the Ignition wire of the vehicle. The source
wire should have +12 V with the ignition key in the
IGNITION ON (RUN)
Warning: at the ignition switch of certain vehicles,
(+) Ignition
there may be more than one ignition wire. Use the
output (30 A)
5
relay (Pin F) and extra relays to power up any
th
extra ignition wires if necessary. Do not jump wires
at the Ignition Switch: this would compromise the
OEM electrical system.
♦ Parking light flashes to which the text
refers throughout this manual refer to
the parking light output of the unit, not
of the vehicle.
Description
position only.
and
CRANK
positions.
P. 5
Advertisement
Table of Contents
