Table of Contents
Advertisement
3-pin Harness
Wire
VIOLET/BLACK
1
N/A
LIGHT BLUE
2
(-) AUX 1 Output
WHITE/BLACK
3
(–) Parking lights
output
Additional Ports
Port
Temperature
1
Sensor
(Optional)
2
RS-232 Port
3
INV-200 Port
4 Bypass/GPS Port
5
Pager Port
Entering Programming Mode
This allows the installer to program the unit. Once the system is in programming mode, the installer
will have up to 20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu
before the 20-second delay, the system will exit programming mode and the installer will have to
select again one of the 2 methods to get access to it.
Using the Hood Pin
• Press and hold the hood pin for 4 seconds.
• Release the hood pin.
The parking lights will turn
• While the parking lights are
pin once more and release immediately.
The parking lights will turn
20 seconds.
• You now have 20 seconds to select one of the
sub-menus.
P. 14
If no Glow-plug wire is found on the vehicle, the Glow-plug input on the module may be
"timed out". The module will power up the Ignition and Glow-plug circuits and simply wait
for the time-out before starting.
Keeping the Glow-plug input wire of the module unconnected will hold the ignition
the preprogrammed delay.
Please program the tach before connecting the glow-plug input to the vehicle.
500 mA negative output. Can be programmed for the following option:
• Horn confirmation on 1
500 mA negative Parking Light output
Note: Ensure that the voltage does not vary when the dimmer control switch is turned up
or down. If this is the case, it is not the right wire.
There is also a positive Parking Light output. Only one of these two different
outputs needs to be connected.
For D2D connection; is used to interface bypasses and door locks convenience module
(check bypass list for compatibility and functionalities).
Is used to interface the pulse inverter for door locks option.
Is used for analog connection to some bypass units (check bypass list for
compatibility and functionalities).
Is used to connect an optional AS-200P pager (to use this option, make sure to program
pager option in Menu 3, Feature 5, Option 4).
.
ON
, press the hood
ON
and stay
ON
Description
N/A
press of the
st
Description
N/A
Using the Antenna Programming Assistance
•
Make sure that the hood is closed.
•
Turn the ignition key to the
position.
•
Within 5 seconds, press the programming button
on the antenna twice for 1 second each time.
for
ON
The LED will come
• You now have 20 seconds to select one of the
sub-menus.
button.
LOCK
Button (A.P.A.B.)
IGNITION ON (RUN)
solid.
ON
for
ON
Installation Guide
Hide quick links:
Advertisement
Table of Contents
