3. Insert the PCIe card into its slot.
4. Close the PCIe card latch.
Next Steps
"Install the Top Cover" on page 154
■
"Slide the Server Into the Rack" on page 155
■
"Power On the Server" on page 157
■
▼ Add a PCIe Card
Before you begin, complete these tasks:
Read the section,
■
Power off the server, using one of the methods described in the section,
■
Off the System" on page
"Disconnect Power Cords From the Server" on page 68
■
"Extend the Server to the Maintenance Position" on page 70
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 73
■
"Remove the Top Cover" on page 73
■
1. Identify the correct slot for installation.
See
Guidelines" on page
98
SPARC Enterprise T5440 Server Service Manual • June 2011
"Safety Information" on page
67.
"PCIe Device Identifiers" on page 99
100.
63.
and
"PCIe Slot Configuration
"Powering