Fujitsu SPARC Enterprise T5440 Service Manual page 83

ILOM Command
set /SYS/keyswitch_state
value
normal | stby | diag |
locked
set /SUS/LOCATE value=value
[Fast_blink | Off]
(No ILOM equivalent.)
show faulty
(No ILOM equivalent.)
show /SYS/keyswitch_state
ALOM CMT Command
setkeyswitch [-y] value
normal | stby | diag | locked
• -y enables you to skip the
confirmation question when
setting the keyswitch to stby.
setlocator value
[on | off]
showenvironment
showfaults [-v]
showfru [-g lines] [-s | -d] [FRU]
• -g lines specifies the number of
lines to display before pausing
the output to the screen.
• -s displays static information
about system FRUs (defaults to
all FRUs, unless one is specified).
• -d displays dynamic information
about system FRUs (defaults to
all FRUs, unless one is specified).
See "Display Individual
Component Information (ILOM
show Command)" on page
showkeyswitch
Description
Sets the virtual keyswitch.
Turns the Locator LED on the server
on or off.
Displays the environmental status
of the host server. This information
includes system temperatures,
power supply, front panel LED,
hard drive, fan, voltage, and current
sensor status. See
Individual Component Information
(ILOM show Command)" on
page 28.
Displays current system faults. See
"Detecting Faults" on page
Displays information about the
FRUs in the server.
28.
Displays the status of the virtual
keyswitch.
Managing Faults
"Display
34.
61