Pcie Slot Configuration Guidelines - Fujitsu SPARC Enterprise T5440 Service Manual

Device
PCIe5
(XAUI1)
PCIe6
PCIe7
Note – PCIe names in ILOM messages are displayed with the full FRU name, such as
/SYS/MB/PCIE0.
Note – In the Solaris OS, PCIe slot addresses are associated with CMP modules. The
PCIe slot address in the Solaris OS might change if you add or remove CMP
modules, or if a CMP module is brought offline. For more information, see the
SPARC Enterprise T5440 Server Product Notes.
Related Information
"Managing Faults" on page 11
■
"PCIe Slot Configuration Guidelines" on page 100
■
"System Bus Topology" on page 167
■
"Performing Node Reconfiguration" on page 159
■

PCIe Slot Configuration Guidelines

You can install up to eight low-profile PCIe in the system. All slots are wired to x8
PCIe lanes. Slot 1 and Slot 7 support graphics cards with x16 connectors. Slot 4 and
Slot 5 also support 10-Gbyte Ethernet cards (XAUI cards). When a XAUI card is
installed, a PCIe card cannot be installed in the same slot.
If you are installing a XAUI card, note the following:
If you are installing a XAUI card in XAUI Port 0, the onboard NET1 port
■
is disabled.
If you are installing a XAUI card in XAUI Port 1, the onboard NET0 port
■
is disabled.
100 SPARC Enterprise T5440 Server Service Manual • June 2011
Device Identifier
/SYS/MB/PCIE5 or
/SYS/MB/XAUI1
/SYS/MB/PCIE6
/SYS/MB/PCIE7
Notes
x8 slot; shared with XAUI slot
x16 slot operating at x8
x8 slot