▼ Add FB-DIMMs
If you are upgrading the system with additional FB-DIMMs, use this procedure.
Before you begin, complete these tasks:
Read the section,
■
Read the sections,
■
Identifiers" on page
Power off the server using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 70
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 73
■
"Remove the Top Cover" on page 73
■
"Remove a CMP/Memory Module" on page 104
■
1. Unpackage the FB-DIMMs and place them on an antistatic mat.
2. Ensure that the ejector tabs are in the open position.
3. Line up the FB-DIMM with the connector.
Align the FB-DIMM notch with the key in the connector. This ensures that the
FB-DIMM is oriented correctly.
4. Push the FB-DIMM into the connector until the ejector tabs lock the FB-DIMM
in place.
If the FB-DIMM does not easily seat into the connector, verify that the orientation
of the FB-DIMM is correct. If the orientation is reversed, damage to the FB-DIMM
might occur.
5. Repeat
Step 2
Next Steps
"Install a CMP/Memory Module" on page 105
■
"Install the Top Cover" on page 154
■
"Slide the Server Into the Rack" on page 155
■
"Power On the Server" on page 157
■
FB-DIMM Configuration
This topic includes the following:
"Supported FB-DIMM Configurations" on page 114
■
"Safety Information" on page
"FB-DIMM Configuration" on page 113
116.
67.
through
Step 4
until all the FB-DIMMs are installed.
63.
and
"FB-DIMM Device
Servicing Customer-Replaceable Units
"Powering
113