Fujitsu SPARC Enterprise T5440 Service Manual page 134

Note – Depending on the configuration of ILOM POST variables and whether
POST-detected faults or not, the system might boot, or the system might remain at
the ok prompt. If the system is at the ok prompt, type boot.
d. Return the virtual keyswitch to Normal mode.
-> set /SYS keyswitch_state=Normal
Set 'ketswitch_state' to 'Normal'
e. Switch to the system console and issue the Solaris OS fmadm faulty
# fmadm faulty
4. Switch to the ILOM command shell.
5. Run the show faulty command.
■
-> show faulty
Target
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
■
6. Run the set command.
-> set /SYS/MB/CPU0/CMP0/BR0/CH1/D0 clear_fault_action=True
Are you sure you want to clear /SYS/MB/CPU0/CMP0/BR0/CH1/D0 (y/n)? y
Set 'clear_fault_action' to 'true
112 SPARC Enterprise T5440 Server Service Manual • June 2011
command.
No memory faults should be displayed.
If faults are reported, refer to the diagnostics flowchart in
Flowchart on page 14
If the fault was detected by the host and the fault information persists, the
output will be similar to the following example:
| Property
| fru
| timestamp
| sunw-msg-id
|
| uuid
|
| timestamp
|
If the show faulty command does not report a fault with a UUID, then you
do not need to proceed with the following step because the fault is cleared.
for an approach to diagnose the fault.
| Value
| /SYS/MB/CPU0/CMP0/BR0/CH1/D0
| Dec 14 22:43:59
| SUN4V-8000-DX
|
| 3aa7c854-9667-e176-efe5-e487e520
| 7a8a
| Dec 14 22:43:59
|
FIGURE: Diagnostic