Remove A Hard Drive - Fujitsu SPARC Enterprise T5440 Service Manual

9. Type the iostat -E command. Type:
# iostat -E
The iostat -E command displays information about your system's installed
devices such as manufacturer, model number, serial number, size, and system
error statistics.
Sample Ap_id Output
EXAMPLE:
Ap_id
c0
c0::dsk/d1t0d0
c0::sd1
usb0/1
usb0/2
usb0/3
usb1/1
usb1/2
usb1/3
usb2/1
usb2/2
usb2/3
usb2/4
usb2/5
usb2/6
usb2/7
usb2/8
---------------------------------

▼ Remove a Hard Drive

If you are removing a hard drive as a prerequisite for another service procedure,
follow the steps in this section.
Before you begin, complete these tasks:
Read the section,
■
Power off the server, using one of the methods described in the section,
■
Off the System" on page
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 73
■
Do the following :
Type Receptacle
scsi-bus connected
disk connected
disk connected
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
"Safety Information" on page
67.
Occupant
configured
configured
unconfigured unknown
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
63.
Servicing Customer-Replaceable Units
Condition
unknown
unknown
"Powering
81