Fujitsu SPARC Enterprise T5440 Service Manual page 84

ILOM Command
show /SYS/LOCATE
show /SP/logs/event/list
show /SYS
The following table shows typical combinations of ALOM CMT variables and
associated POST modes.
Normal Diagnostic Mode
Parameter (Default Settings)
diag mode normal
keyswitch_state normal
diag_level max
diag_trigger power-on-reset
error-reset
diag_verbosity normal
Description of POST This is the default POST
execution configuration. This
configuration tests the
system thoroughly, and
suppresses some of the
detailed POST output.
Related Information
"Diagnostic Flowchart" on page 13
■
"Detecting Faults Using LEDs" on page 34
■
"ILOM-to-ALOM CMT Command Reference" on page 58
■
SPARC Enterprise T5440 Server Administration Guide
■
Integrated Lights Out Manager 3.0 Supplement for the SPARC Enterprise T5440 Server
■
62 SPARC Enterprise T5440 Server Service Manual • June 2011
ALOM CMT Command
showlocator
showlogs [-b lines | -e lines |
-v] [-g lines] [-p
logtype[r|p]]]
showplatform [-v]
No POST Execution
Off
normal
N/a
None
N/a
POST does not
run, resulting in
quick system
initialization. This
is not a suggested
configuration.
Description
Displays the current state of the
Locator LED as either on or off.
Displays the history of all events
logged in the service processor
event buffers (in RAM or the
persistent buffers).
Displays information about the
operating state of the host system,
the system serial number, and
whether the hardware is providing
service.
Diagnostic Service Keyswitch Diagnostic
Mode Preset Values
service normal
normal diag
max max
all-resets all-resets
max max
POST runs the full POST runs the full
spectrum of tests spectrum of tests
with the maximum with the maximum
output displayed. output displayed.