Fujitsu SPARC Enterprise T5440 Service Manual page 57

The following table describes which fault LEDs are lit under given error conditions.
Use the ILOM show faulty command to obtain more information about the nature
of a given fault. See
Component Fault Fault LEDs Lit
Power supply • Service Required LED (front and rear
panel)
• Front panel Power Supply Fault LED
• Individual power supply Fault LED
Fan tray • Service Required LED (front and rear
panel)
• Front panel Fan Fault LED
• Individual fan tray Fault LED
• Overtemp LED (if overtemp condition
exists)
Hard drive • Service Required LED (front and rear
panel)
• Individual hard drive Fault LED
CMP module • Service Required LED (front and rear
or memory panel)
module
• CMP Module Fault LED or Memory
Module Fault LED
FB-DIMM • Service Required LED (front and rear
panel)
• CMP Module Fault LED or Memory
Module Fault LED
• FB-DIMM Fault LED (CMP and
memory modules) (when FB-DIMM
Locate button is pressed)
Other • Service Required LED (front and rear
components panel)
"Detect Faults (ILOM show faulty Command)" on page
Additional Information
• "Front Panel LEDs" on page 5
• "Rear Panel LEDs" on page 8
• "Power Supply LED" on page 95
• "Servicing Power Supplies" on page 89
• "Front Panel LEDs" on page 5
• "Rear Panel LEDs" on page 8
• "Fan Tray Fault LED" on page 89
• "Servicing Fan Trays" on page 84
See these sections:
• "Front Panel LEDs" on page 5
• "Rear Panel LEDs" on page 8
• "Hard Drive LEDs" on page 84
• "Servicing Hard Drives" on page 76
A lit CMP module or memory module fault LED
might indicate a problem with an FB-DIMM
installed on the CMP module, or a problem with
the CMP module itself.
See these sections:
• "Front Panel LEDs" on page 5
• "Rear Panel LEDs" on page 8
• "Servicing CMP/Memory Modules" on page 102
• "Servicing FB-DIMMs" on page 108
See these sections:
• "Front Panel LEDs" on page 5
• "Rear Panel LEDs" on page 8
• "Servicing FB-DIMMs" on page 108
• "FB-DIMM Fault Button Locations" on page 117
Not all components have an individual component
Fault LED. If the Service Required LED is lit, use
the show faulty command to obtain additional
information about the component affected. See
these sections:
• "Front Panel LEDs" on page 5
• "Rear Panel LEDs" on page 8
37.
Managing Faults 35