Configuring Radio Settings For Device Groups - Dell PowerConnect W-Airwave User Manual

9. Locate the RADIUS Accounting Servers area on the Groups > SSIDs configuration page and define the
settings.
Table 61 Groups > SSIDs > Radius Accounting Servers Fields and Default Values
Setting
RADIUS Accounting Server
1-3 (Cisco WLC, Proxim Only)
Accounting Profile Name
(Proxim Only)
Accounting Profile Index
(Proxim Only)
10. Select Save to retain these Security configurations for the group, select Save and Apply to make the changes
permanent, or select Revert to discard all unapplied changes.
11. Continue with additional security-related procedures in this document for additional RADIUS, and SSID
settings for device groups, as required.

Configuring Radio Settings for Device Groups

The Groups > Radio configuration page allows you to specify detailed RF-related settings for devices in a
particular group.
NOTE: If you have existing deployed devices, you may want to use the current RF settings on those devices as a guide for
configuring the settings in your default Group.
Perform the following steps to define RF-related radio settings for groups.
1. Go to the Groups > List page and select the group for which to define radio settings by selecting the group
name. Alternatively, select Add from the Groups > List page to create a new group, define a group name. In
either case, the Monitor page appears.
2. Go to the Groups > Radio page.
Dell PowerConnect W-AirWave 7.4 | User Guide
Table 61 describes the settings and default values.
Default
None
None
None
Figure 44
Description
Pull-down menu selects RADIUS Accounting servers previously entered on the
Groups > RADIUS configuration page. These RADIUS servers dictate where the AP
sends RADIUS Accounting packets for this SSID/VLAN.
Sets the Accounting Profile Name for Proxim AP-600, AP-700, AP-2000, AP-4000.
Sets the Accounting Profile Index for Proxim AP-600, AP-700, AP-2000, AP-4000.
illustrates this page.
Configuring and Using Device Groups in AirWave | 87