Setting Up Device Types; Configuring Cisco Wlse And Wlse Rogue Scanning; Introduction To Cisco Wlse - Dell PowerConnect W-Airwave User Manual

Setting Up Device Types

On AMP Setup > Device Type Setup, you can define how the Device Type displayed for users on your network
is calculated from available data. The first matching property is used. These rules cannot be edited or deleted, but
only reordered or enabled.
You can change the priority order of rules by dragging and dropping rows, as shown in
Check or uncheck the checkbox under the Enabled column to turn device setup rules on or off.
Refer to
column that appears in Clients list tables.
Figure 30 AMP Setup > Device Type Setup Page Illustration

Configuring Cisco WLSE and WLSE Rogue Scanning

The Cisco Wireless LAN Solution Engine (WLSE) includes rogue scanning functions that AirWave supports.
This section contains the following topics and procedures, and several of these sections have additional sub-
procedures:

Introduction to Cisco WLSE


Configuring WLSE Initially in AirWave

Configuring IOS APs for WDS Participation

Configuring ACS for WDS Authentication

Configuring Cisco WLSE Rogue Scanning

You must enter one or more CiscoWorks WLSE hosts to be polled for discovery of Cisco devices and rogue AP
information.
Introduction to Cisco WLSE
Cisco WLSE functions as an integral part of the Cisco Structured Wireless-Aware Network (SWAN)
architecture, which includes IOS Access Points, a Wireless Domain Service, an Access Control Server, and a
WLSE. In order for AirWave to obtain Rogue AP information from the WLSE, all SWAN components must be
properly configured.
Table 34 Cisco SWAN Architecture Components
SWAN Component
WDS (Wireless Domain
Services)
58 | Configuring AMP
"Monitoring and Supporting WLAN Clients" on page 196
Table 34 describes these components.
Requirements
 WDS Name
Primary and backup IP address for WDS devices (IOS AP or WLSM)

WDS Credentials APs within WDS Group

NOTE: WDS can be either a WLSM or an IOS AP. WLSM (WDS) can control up to 250 access
points. AP (WDS) can control up to 30 access points.
Figure
for more information on the Device Type
Dell PowerConnect W-AirWave 7.4 | User Guide
30.