Automatically Provisioning Aps Onto A Floor Plan - Dell PowerConnect W-Airwave User Manual

7. Once all APs are provisioned on the floor plan, select Save (floppy disk icon) in the top right of the QuickView
window.
NOTE: The floor is submitted to one of the core threads to recalculate path loss and then to one of the location caching threads to
recalculate client locations. All changes may not be visible on a refresh until this process complete.

Automatically Provisioning APs onto a Floor Plan

To automatically provision your access points onto your floor plan:
1. Select Draw Region from the Edit menu. A new provisioning popup appears as shown in
pointer.
Figure 226 Planning Region Drawing and Selection Illustration
2. Draw your polygon as follows:


3. Once you have finished drawing the region, enter a name for the region and select a Region Type of Planning.
Then select OK.
4. Enter the following information into the Autoprovision APs window as described in
in Figure
Table 149 Fields in the Autoprovision APs Window
Field
Device Selection
AP Type
Radio Section
Phy
Xmit
Gain
286 | Using VisualRF
Left-click to initiate the process. The tool will automatically shade in your provisioning area.
Complete the polygon by double-clicking.
227:
Description
The type of AP used in this planning region.
Whether they PHY is set to 11n or no radio.
Transmit power of the APs.
Gain of the APs.
4.
Table 149
Dell PowerConnect W-AirWave 7.4 | User Guide
with a crosshair
and illustrated