Configuring Group Ssids And Vlans - Dell PowerConnect W-Airwave User Manual

Table 55 Groups > Security Page Fields and Default Values (Continued)
Setting
Authentication Profile
Name
Authentication Profile
Index
RADIUS Accounting Servers Section
RADIUS Accounting Server
#1 - #4
Authentication Profile
Name
Authentication Profile
Index
MAC Address Authentication Section
MAC Address
Authentication
MAC Address Format
Authorization Lifetime
Primary RADIUS Server
Reattempt Period
3. Select Save to retain these security configurations for the group, select Save and Apply to make the changes
permanent, or select Revert to discard all unapplied changes.
4. Continue with additional security-related procedures in this document for additional RADIUS and SSID
settings for device groups, as required.

Configuring Group SSIDs and VLANs

The Groups > SSIDs configuration page allows you to create and edit SSIDs and VLANs that apply to a device
group. Perform these steps to create or edit VLANs and to set SSIDs.
NOTE: WLANs that are supported from one or more Cisco WLC controllers can be configured on the Groups > Cisco WLC Config
page.
Dell PowerConnect W-AirWave 7.4 | User Guide
Default Description
AMP- For Proxim devices only, this field sets the name of the authentication profile to be
Defined supported in this device group.
Server #1
1 For Proxim devices only, this field sets the name of the authentication profile index
to be supported in this device group.
Not selected Defines one or more RADIUS Accounting servers to be supported in this device
group. Select up to four RADIUS accounting servers from the four drop-down
menus.
For Proxim devices only, this field sets the name of the accounting profile to be
supported in this device group.
3 For Proxim devices only, this field sets the name of the accounting profile index to
be supported in this device group.
No If enabled, only MAC addresses known to the RADIUS server are permitted to
associate to APs in the Group.
Single Dash Allows selection of the format for MAC addresses used in RADIUS authentication
and accounting requests:
 Dash Delimited: xx-xx-xx-xx-xx-xx (default)
 Colon Delimited: xx:xx:xx:xx:xx:xx
 Single-Dash: xxxxxx-xxxxxx
No Delimiter: xxxxxxxxxxxx

This option is supported only for Proxim AP-600, AP-700, AP-2000, AP-4000, Avaya
AP3/4/5/6/7/8, HP ProCurve 520WL
1800 Sets the amount of time a user can be connected before reauthorization is required.
The supported range is from 900 to 43,200 seconds.
0 Specifies the time (in minutes) that the AP awaits responses from the primary
RADIUS server before communicating with the secondary RADIUS server, and so
forth
Configuring and Using Device Groups in AirWave | 83