Auditing Pci Compliance On The Network; Introduction To Pci Requirements; Pci Auditing In The Airwave Interface - Dell PowerConnect W-Airwave User Manual

What Next?
Go to additional tabs in the AMP Setup section to continue additional setup configurations.

Complete the required configurations in this chapter before proceeding. AirWave support remains available to

you for any phase of AirWave installation.

Auditing PCI Compliance on the Network

This section describes PCI requirements and auditing functions in AirWave, with the following topics:

Introduction to PCI Requirements



PCI Auditing in the AirWave Interface


Enabling or Disabling PCI Auditing

Introduction to PCI Requirements
AirWave supports wide security standards and functions in the wireless network. One component of network
security is the optional deployment of Payment Card Industry (PCI) Auditing.
The Payment Card Industry (PCI) Data Security Standard (DSS) establishes multiple levels in which payment
cardholder data is protected in a wireless network. AirWave supports PCI requirements according to the
standards and specifications set forth by the following authority:
Payment Card Industry (PCI) Data Security Standard (DSS)

PCI Security Standards Council Website

https://www.pcisecuritystandards.org
PCI Quick Reference Guide, Version 1.2 (October 2008)

https://www.pcisecuritystandards.org/pdfs/pci_ssc_quick_guide.pdf
PCI Auditing in the AirWave Interface
PCI Auditing in AirWave allows you to monitor, audit, and demonstrate PCI compliance on the network. There
are five primary pages in which you establish, monitor, and access PCI auditing, as follows:
The AMP Setup > PCI Compliance page enables or disables PCI Compliance monitoring on the network,

and displays the current compliance status on the network. See
page 66.
The Reports > Definitions page allows you to create custom-configured and custom-scheduled PCI

Compliance reports. See
The Reports > Generated page lists PCI Compliance reports currently available, and allows you to generate

the latest daily version of the PCI Compliance Report with a single select. Refer to
Page Overview" on
The APs/Devices > PCI Compliance page enables you to analyze PCI Compliance for any specific device on

the network. This page is accessible when you select a specific device from the APs/Devices > Monitor page.
First, you must enable this function through AMP Setup. See
page 66.
Dell PowerConnect W-AirWave 7.4 | User Guide
"Reports > Definitions Page Overview" on
page 229.
"Enabling or Disabling PCI Auditing" on
page 227.
"Reports > Generated
"Enabling or Disabling PCI Auditing" on
Configuring AMP | 65