Lenovo ThinkServer TD200 Installation And User Manual page 116

98
ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide
Note: Do not allow the server to fall over.
4. Follow the cabling instructions that come with the adapter to set jumpers or
switches, if there are any. Route the adapter cables before you install the
adapter.
5. Rotate the rear adapter-retention bracket to the open (unlocked) position.
6. If you are installing a full-length adapter, press on the release lever on the right
side of the front adapter-retention bracket to release the retaining tab on the
left side of the bracket.
7. Carefully grasp the adapter by the top edge or upper corner, and move the
adapter directly from the static-protective package to the adapter slot. Align the
adapter with the expansion slot guides; then, press the adapter firmly into the
expansion slot. For a full-length adapter, make sure that the front edge of the
adapter is properly seated in the correct slot in the front adapter-retention
bracket.
Note: Make sure that the adapter is seated correctly in the expansion slot
before you turn on the server. Incomplete installation of an adapter might
damage the system board or the adapter.