Lenovo ThinkServer TD200 Installation And User Manual page 120

102
ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide
4. Remove the air baffle (see "Removing the air baffle" on page 44).
5. Remove the fan cage assembly (see "Removing the fan cage assembly" on
page 46).
6. Install the VRM in the VRM connector:
a. Turn the VRM so that the VRM keys align correctly with the slot connector.
b. Firmly press the VRM straight down into the connector by applying
pressure on both ends of the VRM simultaneously.
1
Heatsink 2
2
Microprocessor release lever
3
VRM connector
4
Microprocessor 2 VRM
5
Alignment key tab
6
Microprocessor 2
7
Alignment key
c. Make sure that the retaining clips are in the locked position when the VRM
is firmly seated in the connector.
d. Make sure that the retaining clips are in the locked position when the VRM
is firmly seated in the connector.
7. Locate the second microprocessor connector on the system board.
8. Install the microprocessor:
a. Touch the static-protective package that contains the microprocessor to any
unpainted metal surface on the server. Then, remove the microprocessor
from the package.
b. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if any is present.
Attention: Make sure that the release latch on the microprocessor socket
is in the fully open position before you insert the microprocessor in the
socket. Failure to do so might result in permanent damage to the
microprocessor, microprocessor socket, and system board.