Removing An Adapter - Lenovo ThinkServer TD200 Installation And User Manual

12. Install the side cover (see "Installing the side cover" on page 134).
13. Lock the side cover.
14. Reconnect the external cables and power cords; then, turn on the attached

Removing an adapter

To remove an adapter, do the following:
1. Read the safety information (see "Safety" on page vii and "Installation
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the side cover" on page 43).
4. Disconnect any cables from the adapter or any cables that impede access to
5. Rotate the rear adapter retention bracket to the open (unlocked) position. If you
6. If necessary, remove the expansion-slot screw at the rear of the adapter.
7. Carefully grasp the adapter by its top edge or upper corners, and pull the
1
Power supply support bracket
2
Power supply release tab
devices and turn on the server.
guidelines" on page 37).
and external cables.
the adapter.
are removing a full-length adapter, open the front adapter-retention bracket also.
adapter from the server.
Attention: Expansion-slot covers must be installed in all empty slots. This
maintains the electronic emissions standards of the computer and ensures
proper ventilation of computer components.
Chapter 5. Installing optional devices and replacing customer replaceable units
95